Filter
Top Products
2
3. Pull the two halves of the thermostat apart so that the interior of the thermostat
is visible. Install one thermostat wire into the “G” terminal of the thermostat and
the other wire into the “W” terminal (it does not matter which wire color is
installed at each terminal). Use the previously mentioned jeweler’s screwdriver to
tighten the retaining screws and tightly secure the wires into the thermostat.
4. With the two halves of the thermostat still apart, be certain to set the selector
switch to “Electric or Heat Pump”.
5. After mounting the thermostat on the wall and reinstalling all panels removed
from the stove, the batteries can be inserted into the thermostat. Once powered on,
the fan control switch (lower left switch) of the thermostat must be slid to the word
“On” and the system control switch (lower right switch) must be slid to the “Heat”
position, as shown below.
Set fan
control
switch to
“On”
Set system
control
switch to
“Hea
t
”
Set switch to
“Electric or
Heat Pump”
Connect one
thermostat wire
“W” terminal.”
Connect one
thermostat wire
“G” terminal.”