Filter
Top Products
10
3. Side Heat Shields
This accessory item
comes with the hardware
(six (6) mounting screws)
necessary to install it on
the rear of the stove. This
is a two-piece heat shield,
but is installed one piece at
a time. There are pre-
punched holes on each
side of the Rear Heat
Shield; while holding each
piece of the Side Heat
Shield in place, align the
pre-punched holes in the
Side Heat Shield with the
existing holes in the Rear
Heat Shield, and fasten
with the screws provided.
See Illustration 1 for
clearances with and
without side heat shields.
Rear Heat Shield
Side
Heat
Shield
Side
Heat
Shield
Illustration 3 – Side Heat Shield and Blower Installation
Install AC-16 Optional
Blower on these (4) mounting
holes. See “Optional Blower
Instructions” on page 3 for
instructions.
Illustration 4
BRICK LAYOUT
1 – 9” x 4” x 1.25” brick (Qty. 14)
2 – 4” x 4.5” x 1.25” brick (Qty. 2)
3 – 4.5” x 4” metal plate
(Ash Drawer Plate, Qty. 1)