England's Stove Works 50-SHW25, 50-TRW25 Stove User Manual


 
Once you have opened the door properly, you should have a bed of hot coals in the
bottom of the firebox. With the use of a poker, pull the bed of hot ashes towards the front
door of the unit, then fill the stove with seasoned wood and burn the unit for
approximately thirty (30) minutes with the door cracked. The next step is to close the
door and the by-pass damper and set the front slide damper to your desired burn. Follow
this procedure each time you fuel your stove.
E. Ash Removal and Disposal
Regularly inspect the ash build-up in your stove and remove as necessary. Ashes
should be placed in a metal container with an airtight lid. Pending disposal, they should
be placed on a non-combustible surface completely away from any combustible
material. The ashes should be retained in the closed container until all cinders have
thoroughly cooled. Note: It is essential that your flue system be checked for creosote
build-up at least twice per month.
SECTION VI: CARE AND MAINTENANCE
A. Catalytic Combustor Maintenance
Note – Your unit will have a 3” thick, 25-cell combustor (manufactured by Applied Ceramics), or it
will have a 1” thick, “ceramic foam” type combustor (manufactured by Clear Skies). The following
instructions apply to both types, unless otherwise specified.
1. To reach the combustor, first take out the Flame Impingement Plate by removing the
four (4) 3/8” brass nuts (they take a 9/16” wrench). Once the nuts are removed the
plate should drop from the four bolts. This will allow you to see the bottom of your
catalytic combustor.
2. For 25-cell Applied Ceramics combustor: If the combustor is plugged up you will see
black soot within the cells on the bottom side of the ceramic piece. This can usually
be removed by brushing the combustor with a soft bristled brush. You can also run a
pipe stem cleaner through each cell for removal of any internal build-up. This type of
cleaning can be done without removing the combustor from the stove.
For 1” thick Clear Skies combustor: Follow the instructions provided by Clear Skies
pertaining to the cleaning of their combustor.
3. Combustor Housing (Part #CA-1710) – This cast iron housing holds the combustor in
place and if it becomes cracked or broken it should be replaced (See Catalytic
Combustor Replacement”).
4. Flame Impingement Plate (Part #IP-24AC) - These units are equipped with a flame
impingement plate designed to keep the flames from directly hitting the combustor,
which also aids in heating up gases before they reach the combustor. If this plate
becomes distorted, it should be replaced (See Step 1, above).
5. The catalytic combustor (Part #AC-6C3) is guaranteed by Applied Ceramics or Clear
Skies, the manufacturers. A separate warranty card will be in the manual for this part
and should be mailed back to the combustor manufacturer. Both combustors are
equivalent, and in the event there is a problem with this item, the manufacturer
should be contacted as listed: