Filter
Top Products
Control Board
The Control Board (Part #PU-CB04) is a digital read-out board. This board offers a wide
variety of settings to operate the unit. This part can be removed from the unit by loosening
the two outside screws and pulling the board back to the inside of the stove. The rear access
panel should be removed prior to removing the control board. A 5-amp “quick-blow” fuse is
used on this Control Board.
NOTE: The bottom three control buttons are preset at the factory and should not require any
changes. See “Operating Instructions” and “Daily Operation” section of the manual for
instructions on other Control Board settings.
Recommended Heat Ranges:
Low Burn: Heat Range setting: 1 Room Air Blower setting: 1
Medium Low: Heat Range setting: 2 – 3 Room Air Blower setting: *
Medium High: Heat Range setting: 5 – 8 Room Air Blower setting: *
High Burn: Heat Range setting: 9 Room Air Blower setting: 9
* NOTE: Blower Speed will automatically be adjusted to the desired Heat Range that you select.
NOTE: The bottom 3 buttons are
pre-set at the factory and do not
need adjustment. Call Service at
(800) 245-6489 if you have
questions or problems.
CAUTION:
Illustration 2a
Control Board
Diagram