Filter
Top Products
Air Inlet Control
Illustration 6
EXPL
O
DED
V
IE
W
Illustration 7
DIRECTIONS FOR INSTALLATION OF
LEGS OR PEDESTAL:
(Stove must be cooled and all ashes cleaned out)
* Remove bricks, disconnect flue, and turn stove on its back.
* If you are replacing existing legs or pedestal, disconnect the
existing legs or pedestal.
To install legs:
1. Each leg will fit into a pre-made slot on each corner of the
bottom of the unit.
2. A 3/8” x 1-1/2” Carriage Bolt and matching nut is supplied with
each leg. Fit a leg into a slot, and match the hole on the leg
with the hole in the slot. Attach the legs one at a time, using
the supplied bolts and nuts. Tighten securely.
To install pedestal:
1. Place spacers (provided) between the slots on the unit and the
pedestal base (one spacer will fit on each side of the
pedestal). Match the four holes in the pedestal (2 on each
side) with the holes in the spacers and slots on the unit.
2. Use the four 3/8” x 1-1/2” Carriage Bolts and nuts (provided) to
attach the pedestal to the base of the stove. Tighten securely.
*
A
fter attaching the legs or pedestal, turn unit upright,
reconnect flue and replace bricks according to manual.
Pedestal
Le
g
s
Spacers (for
pedestal only)