Filter
Top Products
Page 14
12409-2-0403
PROPER INSTALLATION SEQUENCE:
VFYR and VFYM-16RWO Logs (Figure 14)
1. Install front, left log (#1) onto the grate. The left end of front,
left log must be placed to the outside of left grate.
2. Install front, right log (#3) onto right pin and middle pin on
flat portion of main burner.
3. Install middle, left log (#2) onto the left pin on flat portion of
main burner. Pivot tip of middle, left log to lay on front, right
log.
4. Install rear log (#4) onto two pins on rear log support.
Log Placement
VFYR and VFYM-16RWO Logs Shown
Figure 14
PROPER INSTALLATION SEQUENCE:
VFYR and VFYM-(18, 24, 30)RWO Logs (Figure 15)
1. Install front, left log (#1) onto the grate. The left end of front,
left log must be placed to the outside of left grate.
2. Install front, right log (#3) onto right pin and middle pin on
flat portion of main burner.
3. Install middle, left log (#2) onto the left pin on flat portion of
main burner. Pivot tip of middle, left log to lay on front, right
log.
4. Install rear log (#4) onto two pins on rear log support.
5. Install top log (#5) onto pin on rear log. Tip of top log will lay
on front, right log.
Log Placement
VFYR and VFYM -(18, 24, 30)RWO Logs Shown
Figure 15
LOG PLACEMENT (continued)
PLACEMENT OF GLOWING EMBERS AND LAVA ROCK
Provided with the log set is a small bag of glowing embers (rock
wool) to be placed between logs on the flat metal surface of the
burner.
Placement of the glowing embers (rock wool) is very individual
and light coverage of the areas indicated will provide your best
effects. We recommend separation of the rock wool by hand and
make your coverage as light and fluffy as possible.
Place just enough embers on the burner to obtain the glow and a
gold yellow flame.
Do not place embers (rock wool) over large ports in rear portion
of burner.
A thin layer of glowing embers (rock wool) should be placed
under open space between the right and left middle logs.
Rock wool should not be placed in the area of the pilot assembly.
Placing Lava Rock in Front of Grate and Burner Pan on Fire-
place Floor
Spread lava rocks on fireplace floor in front of grate and burner
pan. The lava rocks are for decorative effect and are not required
for fireplace operation.
ATTENTION: DO NOT PLACE LAVA ROCKS ON LOGS
OR ROCK WOOL. THE LAVA ROCKS SHOULD ONLY
BE PLACED ON THE FIREPLACE FLOOR.
TOP VIEW OF LOG SET
REAR LOG
Placement of Glowing Embers (rock wool)
For All Logs
Figure 16