EMI EMI Corp Heat Pump User Manual


 
www.enviromaster.com
6
Multi-zone Heat Pump Condensing Units
ELECTRICAL WIRING INSTALLATION SECTION
3. Use only HACR type breakers or time
delay fuses. Select the wire size accord
-
ing to the ampacity rating.
4. To access electrical connections and
wiring diagram:
a) Remove the screws on the side panel
adjacent to the back panel.
b) The screws adjacent to the front
panel should already be loose (don't
remove them).
1. All electrical wiring must be run according
to NEC and local codes.
2. Refer to the unit rating plate for voltage,
minimum circuit ampacity and over cur
-
rent protection requirements.
c. Slide the side panel out to access the
high/low electrical connections and
wire diagram.
Note: Remove the plastic edge guards
from the holes and replace with a water-
tight
strain relief fitting (High V) and a
split grommet fitting (Low V)
5. Power should be run to a weather proof
disconnect box usually within 3 feet of
the unit.
6. From the disconnect box, run the power
through the 7/8" hole on the side of the
unit and into the electrical box and an-
chor with the strain relief fitting.
7. Run wires to the high Volt pigtail in the con
-
trol box and attach L1 and L2 connections.
Also run green wire to ground wire.
The EMI America Series condensing
unit must:
• Be connected to a properly grounded
electrical supply with the proper voltage
as stated on the rating plate.
• Have proper over current protection (i.e.
time- delay fuse/HACR-Breaker) as listed
on the Rating Plate.
Failure to follow these instructions can re
-
sult in a fire, explosion, or electrical shock
causing property damage, personal injury,
or death.
DANGER
!
!
Do not use the EMI America Series
condensing unit with any electrical supply
voltage other than the one listed on the
rating plate.
Check the rating plate on the unit for the
correct voltage rating. Failure to use the
correct voltage may result in death, serious
bodily injury or property damage. If you have
any questions or doubts, consult the factory
before installing this unit.
DANGER
!
!
Rating
Plate