Filter
Top Products
1. Attach the appropriate J-hook to the
building structure member.
On Steel Beam - Locate and drill a
13/32” diameter hole in the beam.
(See Figure 5.) Use a flat washer, lock
washer and nut on both sides of the
beam. Position the J-hook so that the
hook extends 2-1/2” out of outlet box.
Securely tighten both nuts. (See
Figure 5.)
CAUTION: When the threaded bolt
hook is used, be careful to securely
tighten with supplied lockwashers and
nuts.
On Wood Joist - Locate and drill a pilot
hole in the wood joist. Install the screw
type J-hook so that hook extends 2-1/2”
below the outlet box. (See Figure 6.)
CAUTION: The pilot hole should be
drilled no larger than the minor
diameter of the screw threads on the
hook (1/4” max.). Do not put a lubricant
on the J-hook. At least 1-1/2” of the
screw threads should be secured into
the structural wood joist.
Hanging Your Heat Fan
5
Turning off wall switch is not sufficient.
To avoid possible electrical shock, be
sure electricity is turned off at the main
fuse box before wiring. All wiring must be
in accordance with National and Local
codes and the ceiling fan must be
properly grounded as a precaution
against possible electrical shock.
WARNING
To reduce the risk of fire, electric shock,
or personal injury:
a. The fan must be hung with at least 10
foot of clearance from floor to blades.
(See Figure 4).
b. Your support beam or joist must be
secure and capable of withstanding a
load of at least 50 pounds.
WARNING
The fan must be hung with at least 10' of
clearance from floor to blades (Figure 4).
WARNING
CEILING
FLOOR
10 FOOT
MINIMUM
Figure 4
NUT
LOCK WASHER
FLAT WASHER
OUTLET
BOX
2-1/2"
Figure 5
2-1/2"
1-1/2"
OUTLET
BOX
Figure 6
STEEL
BEAM
WOOD JOIST
Read and follow instructions carefully.
Failure to comply with instructions could
result in risk of fire, electric shock, fan
falling and injury to persons.
WARNING
J-Hook must be supported by building
structure.
WARNING
U.L. Model No.: HF948, HF956
BP7311 48 56" Heat Fans 1/16/08 10:52 AM Page 5