Filter
Top Products
8
1.Restore electrical power to the outlet box by turning
the electricity on at the main fuse box.
2. Remove the battery cover by pressing firmly on the
arrow and sliding the cover off the control
transmitter.
3. Engage the connector in the transmitter with the
terminals of a 9-volt alkaline battery (not supplied)
(Figure 13).
4. Position the battery in the transmitter and replace
the battery cover.
5. Operate ceiling fan using the Remote Control
transmitter.
Using Your Ceiling Fan
Setting Receiver Frequency
1. After electricity has been turned off at the main fuse
box, locate the receiver switch opening located on
top of the upper housing (Figure 13).
2. Set the position of all four levers, ON or OFF to the
same position as those on the transmitter.
Operation of Your Remote Control
IMPORTANT
Fan installation must be completed, including the
installation of the fan blades, before testing of the
remote control.
Your remote control has full control of your fan and
lights.
1. To set the desired fan speed, press the HI, MED,
or LOW buttons to operate your fan on high,
medium, or low speed (See Figure 14).
2. To turn your fan off, press the FAN/OFF button.
3. To change the airflow direction of the fan blades,
press the FOR/REV button. The direction the fan
blades turn will change each time the FOR/REV
button is pressed.
4. To set the level of light brightness, press and hold
the LIGHT DIMMER button. The light brightness
will continue to increase then decrease while the
button is held down. When the light is at the
desired brightness, release the button.
5. To turn the light ON or OFF, press and release the
LIGHT DIMMER button. The light will turn ON at
the light level previously set (See Step 4).
Red light turns on when any button is pressed.
If the light does not come on, replace the battery.
REMOTE CONTROL
TRANSMITTER
STORAGE BRACKET
FAN/OFF
FOR/REV
LIGHT
DIMMER
HI
MED
LOW
®
TAB
Installation of
Storage Bracket
A storage bracket is supplied with the remote control
for holding the transmitter when not in use. If you
desire to use the bracket, use the two screw
(supplied) and install it on a wall that is away from
excess heat or humidity. When installing, orient the
bracket so that the tab is at the top and away from
the wall (See Figure 14).
Figure 14