Filter
Top Products
How To Put Your Ceiling Fan Together
1. Align the four holes in the fan housing with the
holes in the mounting plate and install four 3/16-24
x 3/8" screws (Figure 6).
2. Mount the blade flanges to the fan blades using
three 3/16-24 x 9/32" washer head screws per
blade (supplied) (Figure 7). Repeat for four
remaining blades.
3. Attach one blade assembly to the motor using two
1/4-20 x 1/2" phillips head screws (supplied)
(Figure 8). Make sure the screws are tightened
securely. Repeat this procedure for the other four
blade assemblies.
NOTE: Take care not to scratch the fan housing
when installing the blade assemblies.
4. You have now completed the assembly of your new
ceiling fan.
1/4-20 x 1/2" SCREWS (2)
BLADE FLANGE
BLADE
Figure 8
BLADE
FLANGE
FAN BLADE
3/16-24 x 9/32" WASHER
HEAD SCREWS (3)
Figure 7
FAN
HOUSING
3/16-24 x 3/8" SCREW
Figure 6
Using Your Ceiling Fan
1. Restore electrical power to the electrical box by
turning the electricity on at the main fuse box or
circuit breaker panel.
2. Check the operation of the fan by gently pulling on
the pull chain switch.
3. All fans are shipped from the factory with the re-
versing switch positioned to circulate air downward.
If airflow is desired in opposite direction, turn your
fan off and wait for the blades to stop turning, then
slide the reversing switch to opposite position, and
turn fan on again. The fan blades will turn in the
opposite direction and reverse the airflow.
Your fan model is equipped with a 4-position,
3-speed pull chain switch. The operating sequence
is as follows:
REVERSING
SWITCH
SPEED
CONTROL SWITCH
Figure 9
6
THREE SPEED:
1st Pull – High
2nd Pull – Medium
3rd Pull – Low
4th Pull – OFF
To reduce the risk of personal injury, do not bend the
blade flange when installing the blade flanges,
balancing the blades or cleaning the fan. Do not
insert foreign objects in between rotating fan blades.
WARNING
!
To reduce the risk of fire or electrical shock, do not
use this fan with any solid-state speed control
device.
WARNING
!