Filter
Top Products
4
1. Rotate the motor hub to align the hub notch area
over each of the five screws which is holding the
shipping retainer to the motor assembly. One by
one unscrew each screw and discard screw and
shipping reatiner (Figure 1).
BLADE FLANGE
M5 x 12mm WASHER
HEAD BLADE SCREW
(4 per blade/flange)
FAN BLADE
To reduce the risk of personal injury, do not bend the
blade flange when installing the blade flanges,
balancing the blades or cleaning the fan. Do not
insert foreign objects in between rotating fan blades.
WARNING
!
Figure 2
MOTOR HUB
N
O
T
E
!
R
e
m
o
v
e
R
u
b
b
e
r
P
a
c
k
i
n
g
M
o
u
n
t
s
A
n
d
D
i
s
c
a
r
d
B
e
f
o
r
e
I
n
s
t
a
l
l
a
t
i
o
n
.
N
O
T
A
!
Q
u
i
t
a
r
L
o
s
S
o
p
o
r
t
e
s
D
e
G
o
m
a
P
a
r
a
E
m
b
a
l
a
J
e
Y
T
i
r
a
r
L
o
s
A
n
t
e
s
D
e
L
a
I
n
s
t
a
l
a
c
i
o
n
.
REMOVE SHIPPING RETAINER
BY REMOVING 5 SCREWS
Figure 1
2. Mount blade flanges (supplied with fan) to fan
blades (sold separately) using four M5 x 12mm
washer head blade screws (supplied with fan)
(Figure 2).
NOTE: Take care not to scratch fan housing when
installing blades.
3. Loosely attach one blade/flange assembly to the
motor hub by secureing the two M6 x 14mm
captive pan head screws. Make sure the screws
are NOT
tightened (Figure 3). Repeat this
procedure for other four blade assemblies.
How to Put Your Ceiling Fan Together
Electrical Requirements
If your fan is to replace an existing ceiling light fixture,
turn electricity off at the main fuse box at this time and
remove the existing light fixture.
Your new ceiling fan will require a grounded electrical
supply line of 120 volts AC, 60 Hz, 15 amp circuit.
The outlet box must be securely anchored and
capable of withstanding a load of at least 50 pounds.
To avoid fire or shock, follow all wiring instructions
carefully. Any electrical work not described in these
instructions should be done or approved by a
licensed electrician.
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is
turned off at the main fuse box before wiring. All
wiring must be in accordance with National and
Local codes and the ceiling fan must be properly
grounded as a precaution against possible electrical
shock.
WARNING
!
WARNING
!
To reduce the risk of fire, electrical shock, or
personal injury, mount fan to outlet box marked
“Acceptable for Fan Support of 50 lbs or less”, and
use screws supplied with outlet box. Most outlet
boxes commonly used for support of light fixtures
are not acceptable for fan support and may need to
be replaced. Consult a qualified electrician if
in doubt.
WARNING
!
U.L. Model No.: CF787