Filter
Top Products
4
2. Remove the three switch cup screws from the
switch housing plate. Position the switch housing
assembly on the switch housing plate and align the
holes in the switch housing assembly with the
holes in the plate. Secure the switch housing
assembly by installing the three screws (Figure 2).
3. Pass the 80" motor leads through the opening in
the ceiling cover. Be sure the cover is oriented
correctly.
4. Separate, untwist and unkink the three motor
leads. Route the motor leads through the hanger
ball/downrod assembly.
5. Remove the upper setscrew from the motor
coupling. Align the clevis pin holes in the
downrod with the holes in the motor coupling.
Install the clevis pin and secure with the hairpin
clip (Figure 3). The clevis pin must go through the
holes in the motor coupling and the holes in the
downrod. Be sure to push the straight leg of the
hairpin clip through the hole near the end of the
clevis pin until the curved portion of the hairpin
clip snaps around the clevis pin. The hairpin clip
must be properly installed to prevent the clevis
pin from working loose. Pull on the hanger ball to
make sure the clevis pin is properly installed.
6. Install the 3/16-24 x 1/2’ screw with jam nut
(supplied) in the motor coupling (Figure 3). While
pulling up on the hanger ball, securely tighten the
setscrew. Then securely tighten the nut against
the motor coupling.
NOTE: The setscrew must be properly installed
as described above, or fan wobble could result.
7. The fan comes with blue, black and white leads
that are 80” long. Before installing fan, measure
up approximately 6 to 9-inches above top of
hanger ball/downrod assembly. Cut off excess
leads and strip back insulation 1/2-inch from end
of leads.
8. Turn fan assembly upside down in preparation for
mounting fan blade assemblies.
9. Mount blade flanges to fan blades using three
3/16-24 x 5/16” screws per blade (Figure 4).
10. Attach blade assembly to motor hub using two
1/4-20 x 1/2” Phillips oval head flange screws.
Make sure the screws are tightened securely
(Figure 5). Repeat this procedure for other four
blade assemblies.
NOTE: Take care not to scratch fan housing when
installing blades.
11. You have now completed the assembly of your
new ceiling fan. You can now proceed with the
hanging and the electrical wiring of your fan.
MOUNTING
SCREWS (3)
SWITCH
HOUSING
ASSEMBLY
SWITCH HOUSING
PLATE
Figure 2
Figure 4
MOTOR COUPLING
CEILING
COVER
CLEVIS
PIN
HAIRPIN
CLIP
CLEVIS
PIN
HANGER BALL/
DOWNROD ASSEMBLY
3/16-24 x 1/2" SCREW
WITH JAM NUT
(3) 3/16-24 x 5/16" SLOTTED PHILLIPS
WASHER HEAD BLADE SCREWS
FAN BLADE
BLADE FLANGE
Figure 3
To avoid possible fire or shock, do not pinch wires
between the switch cup assembly and the switch
BLADE
ASSEMBLY
BLADE FLANGE
SCREWS
Figure 5
WARNING
!
It is critical that the clevis pin in the motor coupling
is properly installed and the setscrew securely
tightened. Failure to verify that the pin and setscrew
are properly installed could result in the fan falling.
WARNING
!
To reduce the risk of personal injury, do not bend the
blade flanges when installing the flanges, balancing
the blades, or cleaning the fan. Do not insert foreign
objects in between rotating fan blades.
WARNING
!