Emerson CF680WB00 Fan User Manual


 
BLACK
BLACK FAN WIRE
LISTED OUTLET BOX
GREEN WIRE
(GROUND)
FROM
HANGER
BRACKET
WHITE
GREEN WIRE (GROUND)
FROM HANGER BALL
GROUND
WIRE
BLUE
RED
LISTED WIRE CONNECTOR (4)
LIGHT
SWITCH
TO 120
VOLT
SUPPLY
GROUND
WHT.
FAN SWITCH
BLACK
(HOT)
GROUND
THREE-CONDUCTOR CABLE
(WITH GROUND) BETWEEN
CEILING AND WALL OUTLET
BOXES
GENERAL PURPOSE
ON-OFF WALL
SWITCHES OR
OPTIONAL EMERSON
FAN/LIGHT CONTROLS
Figure 14
11
3. If you are going to use a single wall
switch or optional Emerson fan
control to control your ceiling fan,
housing lights, and optional Emerson
Light Fixture (if installed) simultane-
ously, you will need a standard two-
wire (with ground) conductor cable
between the ceiling and wall outlet
boxes. The fan speed and the
housing lights can then be operated
from the pull chain switches in the
switch cup housing (or by an optional
Emerson fan control); the optional
light fixture can be operated from the
light fixture switch. Refer to Figure 15
and proceed as follows:
a. Connect the green grounding
lead from the hanger ball and the
green grounding lead from the
hanger bracket to the supply
grounding conductor (this may
be a bare wire or wire with green
colored insulation). Securely
connect wires with a wire
connector (supplied).
b. Securely connect the fan motor
white wire to the supply white
(neutral) wire using a wire
connector (supplied).
c. Securely connect the fan motor
black wire and blue wire to the
supply black (hot) wire using a
wire connector (supplied).
d. After connections have been
made, separate the white and
green wires from the black and
blue wires.
e. Carefully turn the wires upward
and insert them up through the
open side of the hanger bracket
and into the outlet box. Push the
green and white wires into one
side of the outlet box; push the
black and blue wires into the
other side of the outlet box.
Check to see that all connections are
tight, including ground, and that no bare
wire is visible at the wire connectors,
except for the ground wire. Do not
operate fan until blades are in place.
Noise and fan damage could result.
!
WARNING
BP7305 Westfield 6/30/06 12:10 AM Page 11