Emerson CF2400AB00 Fan User Manual


 
5
4. Align the clevis pin holes in the downrod with the
holes in the motor coupling. Install the clevis pin
and secure with the hairpin clip (Figure 2). (Pin and
clip are supplied in loose parts bag.) The clevis pin
must go through the holes in the motor coupling
and the holes in the downrod. Push the straight leg
of the hairpin clip through the hole near the end of
the clevis pin until the curved portion of the hairpin
clip snaps around the clevis pin. The hairpin clip
must be properly installed to prevent the clevis pin
from working loose. Pull the hanger ball to make
sure the clevis pin is properly installed.
5. Install the setscrew (supplied) in the motor coupling
(Figure 2). While pulling up on the downrod, tighten
the setscrew using the setscrew wrench (supplied).
NOTE: The setscrew must be properly installed as
described above, or fan wobble could result.
6. Screw two 1” threaded studs (supplied) into the
motor (Figure 3). Leave approximately 7/8” of the
stud extending above the motor. Coil the wires and
wire connectors around the motor coupling then
slide the motor cover over the downrod and rotate
the cover until the threaded studs protrude. Install
two lockwashers (supplied) to secure the cover to
the motor. All wires and wire connectors must be
enclosed under the motor cover.
NOTE: Lightly snug the knurled knobs and make
sure the wires and wire connectors are
completely inside the motor coupling cover and
not pinched between the motor coupling cover
and the motor.
7. Position the ceiling cover over the downrod. Be
sure the cover is oriented correctly, with the large
opening at the top (Figure 4).
It is critical that the clevis pin in the motor coupling
is properly installed and the setscrew securely
tightened. Failure to verify that the pin and setscrew
are properly installed (as shown in Figure 2) could
result in the fan falling.
WARNING
!
LOCKWASHER (2)
KNURLED
KNOB (2)
MOTOR
COUPLING
MOTOR COVER
1" THREADED
STUD (2)
Figure 3
8. Reinstall the hanger ball on the downrod (Figure 4)
as follows. Route the motor leads through the
hanger ball and slide the hanger ball over the
downrod. Install the pin through the holes at the top
of the downrod and slide the hanger ball up the
downrod, aligning the ball so the pin in captured in
the groove in the top of the hanger ball. Pull the
hanger ball up tight against the pin and securely
tighten the setscrew in the hanger ball. A loose
setscrew could create fan wobble.
9. The fan comes with blue, black and white leads
that are 80-inches long. Before installing the fan,
measure up approximately 6 to 9-inches above
top of hanger ball/downrod assembly. Cut off
excess leads and strip back insulation 1/2-inch
from end of leads.
10. Use three 10-32 x 3/8” Phillips pan head screws
(supplied) and three #10 flat washers to secure
the fan blade to the blade flange (Figure 5).
Repeat this procedure for the remaining four
blades.
It is critical that the pin in the hanger ball is properly
installed and the setscrew securely tightened.
Failure to verify that the pin and setscrew are
properly installed could result in the fan falling.
WARNING
!
CEILING
COVER
DOWNROD
PIN
HANGER BALL
SETSCREW
Figure 4
10-32 x 3/8" PHILLIPS
PAN HEAD SCREWS (3)
#10 FLAT WASHERS (3)
FAN BLADE
BLADE FLANGE
Figure 5