Filter
Top Products
UL Model No.: CF130
NOTE: When installing the ceiling fan
using the close-to-the-ceiling method,
carefully lift the fan assembly from the
hook on the hanger bracket and
proceed as follows.
1. After connections have been made,
turn leads upward and carefully push
leads into the outlet box, with the white
and green leads on one side of the
outlet box and the black and blue leads
on the other inside of the outlet box.
2. Lift the ceiling cover up to the hanger
bracket. Engage the slots in the ceiling
cover with the loosened screws in the
bracket and turn the cover counter-
clockwise (Figure 17). Be sure that the
lockwashers are between the screw
heads and the ceiling cover.
3. Install the remaining two lockwashers
and screws (supplied); tighten all four
screws securely.
11
Installation of
Ceiling Cover For
Close-to-the-Ceiling
1. After connections have been made,
turn leads upward and carefully push
leads into the outlet box, with the white
and green leads on one side of the
outlet box and the black and blue leads
on the other inside of the outlet box.
2. Screw the two 1-1/4” threaded studs
(supplied) into the tapped holes in the
hanger bracket (Figure 18).
3. Lift the ceiling cover up to the threaded
studs and turn until the studs protrude
through the holes in the ceiling cover
(Figure 18).
To avoid possible fire or shock, make
sure that the electrical wires are
completely inside the outlet box and not
pinched between the ceiling cover and
the ceiling.
!
WARNING
Installation of
Ceiling Cover For
Standard Mounting
LOOSEN
THIS
SCREW
INSTALL SCREW
AND LOCKWASHER
CEILING
COVER
TIGHTEN
SCREW
FAN HOUSING
Figure 17
To avoid possible fire or shock, make
sure that the electrical wires are
completely inside the outlet box and not
pinched between the ceiling cover and
the ceiling.
!
WARNING
EXTERNAL TOOTH
LOCKWASHER (2)
CEILING
COVER RING
1-1/4"
THREADED
STUD (2)
CEILING
COVER
#8-32 KNURLED
KNOB (2)
Figure 18
4. Position the ceiling cover ring onto the
threaded studs and secure both the
ceiling cover and ring in place by sliding
lockwashers (supplied) over the
threaded studs and installing the two
knurled knobs (supplied). (Figure 18).
Tighten the knurled knobs securely
until the ceiling cover fits snugly against
the ceiling.
BP7404 Tilo 12/16/09 4:06 PM Page 11