Filter
Top Products
10
ETL Model No.: CF110
This control is designed to operate only one ceiling fan,
(Figure 18). This SW46 speed control is rated for 1.2
amps at 120 volts..
1. Before disconnecting power, ensure that the fan is
set at the highest speed.
NOTE: Electric connections should be in
accordance with the National Electrical Codes and
all Local Codes. Before starting, disconnect power
to the circuit at the fuse box or circuit breaker
panel.
2. Remove the faceplate and screws from the existing
wall switch. Pull switch out from wall outlet box.
3. Disconnect wire from existing fan wall switch (Figure
19).
4. Slide the SW46 speed control in the OFF position (0).
5. Connect one BLACK wire from the SW46 speed
control to the fan/motor lead with a wire connector
(provided). (Figure 20.)
6. Connect the other BLACK wire from the SW46 speed
control to the 120VAC hot wire with a wire connector
(provided).
NOTE: Use wire connectors (supplied) to secure
electrical connections.
7. Attach the SW46 speed control to the wall outlet box
with two 6-32 x 3/4” screws (provided).
Wall Control Installation
4
0
3
2
1
Figure 18
FACEPLATE
SWITCH
WALL
OUTLET
BOX
TO NEUTRAL
TO FAN MOTOR LOAD
MOTOR LOAD
1.2 AMP MAXIMUM
TO
120VAC
SOURCE
HOT
BLACK
BLACK
4
0
3
2
1
Figure 19
Figure 20
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is turned
off at the main fuse box before wiring. All wiring must
be in accordance with National and Local codes and
the ceiling fan must be properly grounded as a
precaution against possible electrical shock.
WARNING
!
CAUTION: To reduce the risk of electrical shock,
disconnect the electrical supply circuit before
installing the fan, light kit or receiver.