Elta LE100 Dehumidifier User Manual


 
HANDLING
Install the device in a place as central as possible or, if necessary, in a particularly humid
place.
Stick the power plug (8) into the socket.
Turn the regulator HUMIDISTAT OFF/MAX (3) on the dehumidifying level you want. The
control lamp (1) lights up. The farther you turn the regulator in the direction MAX, the
more water will be removed from the air. As soon as the air humidity decreases under the
selected value, the dehumidifier shuts down automatically and the control lamp (1)
extinguishes.
If you turn the regulator HUMIDISTAT OFF/MAX (3) on position MAX, the device will run
continuously.
The water removed from air will be collected in the water tank (6). In case the water tank is
full respectively in case it is improperly inserted in the device, the control lamp (2) lights
up.
The device is provided with a 2-phase ventilator. During normal operating turn the switch /
(4) in the position . In case a lower operating is required, turn the switch / (4) in
the position .
In order to shut down the device turn the regulator HUMIDISTAT OFF/MAX (3) on position
OFF.
Emptying the water tank
In case the water tank is full respectively in case it is improperly inserted in the device, the
control lamp (2) lights up.
For emptying remove the water tank (6) with the grip underside the water tank from the
device.
Empty the water tank and reinsert it in the device. After reinserting the control lamp (2)
must extinguish, the device is now ready for use.
Continuous drainage
In case the device will be operated in very high air humidity conditions, the water tank must be
emptied very often. In order to avoid this, the device can be connected to a drainage system.
Turn the device off and pull out the power plug.
Remove the rubber stopper from the water disposal opening (9). Keep the rubber stopper for
future use.
Connect a water disposal tube (not provided) with an inside diameter of 6 mm to a water
disposal opening (9).
Make sure that water runs off properly. Under wintry weather conditions you must take
actions in order to keep the water disposal tube unfrozen.
In order to operate the device without drainage again, remove the water disposal tube and
reinsert the rubber stopper in the water disposal opening (9).
CLEANING AND CARE
It is essential to observe also the
Safety tips
.
Before cleaning turn off the device and empty the water tank.
Wipe regularly the device with a wet cloth.
Do not use any scrubbing cleaning materials or hard cleaning tools.
It is forbidden to use gas or solvent cleaning substances for cleaning.
Filter cleaning
The filter of the device must be cleaned regularly. Remove the water tank and pull out the
filter (see
Before opening
).
Plastic filter: Beat the plastic filter carefully or clean it with the vacuum cleaner. In case the
filter is very dirty, wash the filter in warm water using a mild cleaning agent and dry it.
Reinsert the filter only when it is completely dry.
Active carbon filter: The active carbon filter can not be cleaned. Its useful life depends on
the environmental conditions, but it should be proved every 6 months.
To replace the active charcoal filter (sliceable filters are available in home improvement
stores, for example) remove the filter holder and insert the new active charcoal filter. Replace
the filter holder while making sure that all of the retaining collars are holding the filter holder.
TECHNICAL DATA
Operating voltage: 230-240 V~ 50 Hz
Power input: 250 Watt (at 35 °C air temperature and 80 % air humidity)
Cooling agent: R134a
Quantity of the cooling agent: 100 g
Dehumidification capacity: 10 l/day (at 30 °C and 80 % air humidity)
Operating temperature: 5 - 35 °C
Water tank capacity: 4 l
Dimensions: 270 x 364 x 550 mm
Weight: 13.4 kg
Volume: 40 dB (A)
INSTRUCTIONS ON ENVIRONMENT PROTECTION
Do not dispose of this product in the usual household garbage at the end of its life
cycle; hand it over at a collection point for the recycling of electrical and electronic
appliances. The symbol on the product, the instructions for use or the packing will
inform about the methods for disposal.
The materials are recyclable as mentioned in its marking. By recycling, material recycling or
other forms of re-utilization of old appliances, you are making an important contribution to
protect our environment.
Please inquire at the community administration for the authorized disposal location.
GUARANTEE AND CUSTOMER SERVICE
Before delivery our devices are subjected to rigorous quality control. If, despite all care,
damage has occurred during production or transportation, please return the device to your
dealer. In addition to statutory legal rights, the purchaser has an option to claim under the
terms of the following guarantee:
For the purchased device we provide 2 years guarantee, commencing from the day of sale.
During this period we will remedy all defects free of charge, which can be demonstrably
attributed to material or manufacturing defects, by repair or exchange.
Defects which arise due to improper handling of the device and malfunctions due to
interventions and repairs by third parties or the fitting of non-original parts, are not covered by
this guarantee.
7 8
approved
GB
GB
GB
GB
elta GmbH
Carl-Zeiss-Str. 8
63322 Rödermark
ÕÀÀiÌÊEÊÕÃi\ Ê/ÓÓxä6ÊÀÊÓÓxä6