Filter
Top Products
EN
8
User Manual
BEFORE YOU START
• Ensure that the power pack is switched OFF, before connecting the ZOOM Head.
• Ensure that the ZOOM Head is in a workable condition. Do not use the ZOOM Head if
the connector, cable, flash tube, fan or the housing show any kind of damage.
• Connect the flash head connector to the power pack.
• Only correct fitted flash cable connections are secured against
arching.
• Check all connections again; and than switch on the unit.
ATTENTION
• Always switch off the power pack before connecting or
disconnecting flashheads!
• The ambient temperature whilst the unit is in use: min. -20°C
(-4°F) up to max. 35°C (95°F)
THIRD PARTY MANUFACTURERS
The ZOOM flashhead cannot be connected to power packs from other brands. Even when
similar flashhead sockets and plugs are used by other manufacturers, the wiring of the
contacts and the flash tubes are specifically made for Elinchrom power packs. Use only
original Elinchrom accessories and reflectors. The warranty does not cover damages forced
by third party accessories and reflectors.
ZOOM HEAD ON/OFF SWITCH
The Halogen modelling lamp can be switched on/off directly from the ZOOM Head, if this is
required. It does not switch off the flash light.
ZOOM HEAD INTELLIGENT FAN COOLING AND OVERHEAT
PROTECTION
The fan speed is electronically controlled. Close to the on/off switch is a small LED, which
lights up in case of over heating. The overheat protection shuts down the Halogen lamp at
internal high temperature. After cooling down the Halogen lamp switches on automatically
and the red LED turns off.