Aquapower 2000
2.1
Fountain pump Aquapower 2000
This appliance serves as pump for garden ponds
and fountains. It may be used for pumping water in
non-freezing weather conditions.
The diversion of water flow for creation of a waterfall
or stream is supported, if a hose is connected to the
diverter valve of the riser pipe.
Read these instructions thoroughly before commis-
sioning this appliance. By doing so you can help
prevent personal injury and damage to the appli-
ance.
Safety first!
Please note the following to prevent injury:
-
Check power cable for damage prior to installation and before every use. If the
power cable is damaged, the appliance is faulty and can no longer be used. It
can not be repaired.
-
Never reach into the water before not all submerged electrical equipment is
switched OFF and their power cables unplugged.
-
Operate this pump only on a power source matching the specifications stated in
the „technical specifications“ section, and equipped with a residual current oper-
ated device (RCD) of 30 mA tripping current.
-
Do not operate pump when there are persons in the water.
To prevent damage to the appliance, please note:
-
Use the pump only in liquids with a temperature between 0
°
C and 35
°
C.
-
Never let the pump run dry.
P0005 Seite 1 Freitag, 20. Februar 1998 11:55 Uhr
