Filter
Top Products
Motor will not start. Electric Plug Push plug securely into outlet.
Try another outlet.
Check circuit breaker.
Motor suddenly stops. Thermal Cut Off Refer to page 8.
Does not clean the carpet or Filter(s) Change the filter. Hint: If picking up fine dust, the filter
floor. may not look full, but a fine substance tends to reduce
suction when it blocks the airflow through the filter(s)
Make sure the filter is installed properly.
Make sure filter cover is installed properly.
Belt Replace a cut, loose or out of shape belt.
Brush Roll Clean hair and thread from bristles and end cap area.
Replace brush roll if bristles are worn.
Hose Remove any clogs from the hose that restrict the airflow.
No suction at the end of the Hose Remove any clogs from the hose that restrict the airflow.
hose. Check both ends of the hose. (See page 10)
Noise from the brush roll area. Brush Roll Remove hood and clean debris from the brush roll area.
Belt Replace a cut, loose or out of shape belt.
Cleaner is hard to push. Cleaner Height Setting Turn adjustment knob to a higher position. Hint: Put
handle in operating position. Tilt the cleaner back to
raise the front wheels off floor. Then turn the knob.
Belt Replace a cut, loose and out of shape belt.
Brush roll will not turn. Brush Roll Remove hood and clean debris from the brush roll area.
Belt Replace cut, loose or out of shape belt.
Burning smell. Brush Roll
Remove hood and clean debris from the brush roll area.
Belt Replace cut, loose or out of shape belt.
Cleaning height knob will not Cleaner Height Setting Hint: Put handle in operating position. Tilt the cleaner
turn. back to raise the front wheels off floor. Then turn the
knob.
Missing parts Call Electrolux Customer Services on 08706 055055.
Questions? Call Electrolux on 08706 055055. Have the model
and serial numbers ready when you call. See rating
plate beneath the cleaner.
15
NOTE: Turn off the switch and unplug the electrical cord before servicing.
PROBLEM CAUSE SOLUTION
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓