Electrolux Z430 Series Vacuum Cleaner User Manual


 
5
HOW TO ASSEMBLE
Assemble completely before using.
1. Attaching or Removing Floor Nozzle.
Align the lock button on the floor nozzle neck with the
hole in the receiving tube on the main body. Push the lock
button and slide the floor nozzle into the main body until
it clicks into place. Push the lock button in and pull on the
floor nozzle to remove it from the main body.
2. Attach Handle Grip.
With the cord hook facing the rear of the cleaner, slide the
handle into place over the plastic adaptor.
3. Attach Hose and Hose Holder.
With the smaller side of the hose holder facing the front
of the cleaner, insert into guide channels and snap into
place. Insert the hose end with the guide tabs into the
hose coupling and twist counter clockwise to lock.
4. Store Cord (using cord hooks).
Pull the electrical cord down around the lower cord hook,
then wrap cord around upper and lower cord hooks. Fasten
plug to electrical cord to prevent unwinding.
5. Store Unit.
Push the telescoping handle release button to lower the
handle into its compact storage position. The handle is
locked down when a click is heard.
1
Off / Suction /
Brushroll Switch
Handle Grip
Handle Tube
Dust Cup
Cord Retainer
Cord Hooks
Receiving Tube
Dust Cup
Release Button
Telescoping
Handle Release
Lock Button
Connector Pins
3
2
Clean Out
Port
Brushroll
Clean Out
Port (Open)
Hose
Coupling
Hose Holder
4
6
5
Dusting
Brush
Hose
Actuator
Valve
QUICK REFERENCE
QUICK REFERENCE HOW TO ASSEMBLE
Locked Brushroll
Indicator (Certain
models only)