Filter
Top Products
SCRUBBING AND DRYING OPERATION
14
SCRUBBING AND DRYING OPERATION
11
Press the brush “on/off” push button: the indicator
will light and the brush motors will start.
Lower the brush unit by pushing the pedal to the
right to unlatch it.
Drive the machine forward by holding the hand-
grips. And turning the thumb wheels.
Push the machine slowly forward, and adjust the
squeegee pressure control until the lips bend over
evenly as illustrated below. Then re-adjust the rake
control to make the radius of the squeegee sit
parallel to the floor and the lips bend evenly.
The lips must be replaced when they become
feather edged or torn.
Fully lift the squeegee control lever (just below and
to the right of the machine handle) to lower the
squeegee to a flat floor surface.
If the recovery tank full indicator lights continuosly
for a period of 6 seconds the suction motor will
switch off and the tank will have to be emptied
before continuing the operation.
Note:
Lift the brushes whilst still moving forward then
stop traction, in that order, to avoid “polo rings”.
Lift the squeegee and stop the suction motor. Drive
the machine to an emptying point or use a transfer
trolly to empty the recovery tank.
TRAVEL DIRECTION
FLOOR LEVEL