Electrolux CF921ORB00 Fan User Manual


 
3
ETL Model No.: CF921
EMERSON QUICK START GUIDE
The Quick Start Guide covers the installation
instructions common for ceiling fan operations. If
additional assistance with wiring, alternate hanging
systems, or lighting options, proceed to the complete
instructions of this Owner’s Manual.
The Quick Start Guide sections include page numbers
to correspond with the appropriate sections of the
Owner’s Manual for detailed instructions.
* See Unpacking Instructions for a complete list of
parts for installation.
Installation of Downrod (page 6)
1. Remove the hanger ball from
the downrod.
2. Install the downrod to the
motor coupling using the
clevis pin and hairpin clip.
3. Tighten the setscrews.
1. Disconnect electrical power to
the branch circuit at the
circuit breaker or fuse box
before attempting to install
the ceiling fan hanger bracket
on the outlet box.
AT LEAST
7'
CEILING
FLOOR
2. The fan must be hung with at
least 7’ of clearance from
floor to ceiling.
3. Attach the hanger bracket to
the outlet box.
4. Seat the hanger ball/downrod
assembly on the hanger
bracket.
Hanging Your Ceiling Fan (page 9)
To reduce the risk of fire, electric shock, or personal
injury, mount fan to outlet box marked “Acceptable for Fan
Support of 22.7 kg. (50 lbs.) or less”, and use screws
supplied with outlet box. Most outlet boxes commonly used
for support of light fixtures are not acceptable for fan
support and may need to be replaced. Consult a qualified
electrician if in doubt.
!
WARNING
Installation of Blade Assembly (page 7)
1. Mount blade flanges to fan
blades (sold separately) using
four #10-24 x 12mm washer
head blade screws.
2. Loosely attach one blade
assembly to the motor hub
using two 1/4-20 x 14mm
captive screws with lock-
washers. Make sure the
screws are NOT
tightened.
Repeat this procedure for
other four blade assemblies.
Installation of Switch Housing (page 8)
1. Remove the four switch
housing mounting screws
from the switch housing
plate. Position the switch
housing assembly on the
switch housing plate and
align the holes in the switch
housing assembly with the
holes in the plate. Secure the
switch housing assembly by
installing the four screws.
Installation of Ceiling Fan (page 7)
1. Install the coupler cover and
ceiling cover onto the
downrod.
2. Reinstall the hanger ball onto
the downrod, place the pin
into the hanger ball and
tighten the setscrew.
Turning off wall switch is not sufficient. To avoid possible electrical
shock, be sure electricity is turned off at the main fuse or circuit
breaker box before wiring. All wiring must be in accordance with
National and Local codes and the ceiling fan must be properly
grounded as a precaution against possible electrical shock.
!
WARNING
NOTE: Tuck in both the blue and white wires carefully under the
switch housing cover