Electrolux CF921CK00 Fan User Manual


 
11
Installation of Remote Control Battery
CODE
SWITCHES
SR600 REMOTE
CONTROL
BATTERY
COMPARTMENT
COVER
TWO AAA
BATTERIES
REMOTE CONTROL
LEVERS
ON
1
234
5
I
Figure 13
Your Emerson Ceiling Fan/Light SR600 Remote
Control consists of hand-held transmitter and a
receiver which is mounted under the fan ceiling cover.
The remote control is designed to separately control
your ceiling fan speed, airflow direction and light
intensity.
The remote control transmitter is powered by two
AAA alkaline batteries (included). To prevent possible
damage if the batteries should leak, be sure to
remove the batteries when the control is not to be
used for an extended period of time.
Code switches in the transmitter and receiver may be
set in 32 different positions. If your fan and light go on
and off without using your control, you may be getting
interference from other remote units such as garage
door openers, car alarms or security systems. To
remedy this situations, simply change the
combination code in your transmitter and follow
procedures for Setting Operating Frequency of
Remote Control.
Preset Memory Feature
Your Emerson receiver is equipped with a preset
memory feature. If the AC supply to the receiver is
powered through a wall switch, when the switch is
turned OFF, the control will remember the light
intensity and fan speed. When the switch is turned
back ON the light and fan will resume operation as
they were prior to the switch being turned OFF.
1. Remove the battery cover by pressing firmly below
the arrow and sliding the cover off the control
(Figure 13).
2. Install two AAA alkaline batteries and reinstall the
battery cover.
Setting Operating Frequency of Remote Control
Figure 14
Your remote control has code switches which must be
set in one of 32 possible code combinations. The five
levers (numbered 1, 2, 3, 4, and 5) on the switches
are factory-set in the ON (up) positron. Change the
switch settings as follows (Figure 14).
1. Slide the five switch levers in the remote control to
your choice of ON (up) or down positions. Use a
ball-point pen or small screwdriver and slide the
levers firmly up and down.
2. When power is restored, push and hold the fan
OFF button ( ) for 3 to 5 seconds to set the code
in the reliever.
NOTE: The remote/receiver must be programmed
within 2 minutes of restoring electricity to the fan.
3. The ceiling fan lights will blink when the receiver
has completed programming.
4. If programming fails, shut off and turn on the
electricity at the wall switch to reset the receiver.
Repeat Step 2 above.
5. If programming continues to fail, change the
remote code and repeat Steps 2 and 5 as
necessary until the fan successfully completes the
programming procedure.
ETL Model No.: CF921