Filter
Top Products
3
U.L. Model No.: CF205
This Manual Is Designed to Make it as Easy as Possible for You to Assemble,
Install, Operate and Maintain Your Ceiling Fan
Tools Needed for Assembly
One Phillips head screwdriver One stepladder
One wire cutter One wire stripper
MATERIALS
Wiring outlet box and box connectors must be of
type required by the local code. The minimum wire
would be a 3-conductor (2-wire with ground) of the
following size:
Installed Wire Length Wire Size A.W.G.
Up to 50 ft. 14
50-100 ft. 12
Before assembly your ceiling fan, refer to section
on proper method of wiring your fan (page 6).
If you feel you do not have enough wiring knowl-
edge or experience, have your fan installed by a
licensed electrician.
WARNING
!
Unpacking Instructions
1. Open styrofoam unit containing fan. Remove top
half of styrofoam unit. Remove parts and check to
see that you have received the following parts:
NOTE: If you are uncertain of part description,
refer to exploded view illustration.
a. Fan motor/housing assembly
b. One ceiling cover
c. One coupling cover
d. Three fan blades
e. Three blade flanges
f. Nine decorative blade nuts (bagged)
g. One hanger bracket
h. One hanger ball/12” downrod assembly
i. One 6” downrod
j. One rod support assembly
Do not install or use fan if any part is damaged or
missing. Call Toll-Free:
1-800-654-3545
This product is designed to use only those parts
supplied with this product and/or any accessories
designated specifically for use with this product by
Emerson Electric Co. Substitution of parts or acces-
sories not designated for use with this product by
Emerson Electric Co. could result in personal injury
or property damage.
D
K
B
J
C
M
I
H
A
G
L
S
F
R
P
Q
E
N
O
WARNING
!
WARNING
!
k. Three decorative rod assemblies
l. Six decorative rod assembly screws (bagged)
m.One light kit plate
n. One lower glass
o. One cover plate
p. Two 50-watt mini-candelabra base
halogen bulbs
q. One remote control transmitter
r. One remote control receiver
s. One loose parts bag, containing:
1. Two 1-1/4” threaded studs
2. Two knurled knobs
3. Two lockwashers
4. Seven wire connectors
5. One hairpin clip
6. One clevis pin
7. Seven 1/4-20 x 11mm pan head screws
(bagged)
8. Ten 10-24 x 9mm oval head screws (bagged)
NOTE: Place the parts from the loose parts bags
in a small container to keep them from being lost.
If any parts are missing, contact your local
retailer or catalog outlet for replacement before
proceeding.
2. Remove the fan motor/housing assembly from the
protective plastic bag. Place the fan assembly into
the lower foam pad with the bottom of the motor
facing up.
The lower foam pad serves as a holder for the fan
during the first stages of assembly.