Filter
Top Products
Ei220EN (Only)
1. Slide the cover off as shown in Figure 7 to expose the mounting screw holes.
2. Cut a notch in the back sidewall (on the centre of either side or at the bottom, for
the power cord) to allow the unit to lie flush against the ceiling/wall.
3. Mark the two screw locations. Drill suitable holes (6mm drill) then insert the
plastic anchors and screw the unit to the ceiling/wall.
4. Insert the plug into a suitable socket.
Warning: Do not open (apart
from the cover shown in fig-
ure 7) or tamper with the CO
Alarm. There are no user
serviceable parts inside.
This can damage the unit
and may expose the user to
shock or fire hazards.
18
Figure 7
B15584-R0-225EN&220EN-U&C 6/9/07 8:13 AM Page 18