Ei Electronics Ei2110 Smoke Alarm User Manual


 
3. REGULAR OR IRREGULAR SINGLE BEEPS:
Check the green mains power light is on. If not, check the fuse, circuit breakers and wiring
connections. If the green light is off, the internal back-up cells will deplete after some months
and will need to be recharged. Reinstate the mains supply to the alarm and the back-up cells
will automatically recharge. If the mains has been reinstated for a number of hours and the
beeps have not ceased, a fault may exist. Switch off the mains,remove the unit - (see “ALARM
REMOVAL” section on page 4) and return it to the nearest address given at the end of this
leaflet - see
GETTING YOUR ALARM SERVICED section on page 18.
If the beep occurs at the same time as the amber light on the cover is flashing, then one of
the sensors may be defective. Switch off the mains, remove the unit (see “ALARM
REMOVAL” section on page 4) and return it to the nearest address given at the end of this
leaflet - see
GETTING YOUR ALARM SERVICED” section on page 18.
4. INTERCONNECTED ALARMS DO NOT ALL SOUND:
(1) Hold Test/Hush button for 10 seconds after first alarm has sounded to ensure the
interconnect signal is transmitted to all units.
(2) One or more of the connections may not be correctly connected. We recommend you
consult a qualified electrician.
20
B16351-R0-Ei2100 SERIES-USE.qxd 18/9/08 3:47 PM Page 20