Filter
Top Products
13
Installing the batteries
Cooling Mode:
Cooling mode cools and dehumidifies the air. If the ambient
temperature drops below the temperature you selected, the
compressor turns off and the unit functions with the fan only. When
the temperature rises above the temperature you selected, the
compressor turns on again.
Whether your desired temperature can actually be reached
depends on the ambient conditions. The room temperature
remaining above the set temperature is normal.
To operate the unit in cooling mode:
1) Make sure the power cord is plugged into a power outlet.
2) Press the Power button on the remote.
3) Press the Mode button until the Mode Indicator Light on the
Control Panel turns blue.
4) Select the fan speed by using the Speed button.
5) Set the thermostat by using the Up and Down buttons. The
thermostat is adjustable between 61°F - 86°F in one degree
increments.
Fan Only Mode:
Fan Only mode is used to circulate the air in your room. No
temperature setting is needed.
To operate the unit in Fan Only mode:
1) Make sure the power cord is plugged into a power outlet.
2) Press the Power button on the remote.
3) Press the Mode button until the Mode indicator light turns green.
4) Press the Speed button to select the fan speed. You can choose
between High, Medium and Low. The LED indicator next to the
speed will light up.
CAUTION: Use only AAA
batteries. Remove the batteries
if the remote control will not be
used for one month or longer.
Do not attempt to recharge
batteries not designed to be
recharged. All batteries should
be replaced at the same time.
Do not mix old and new
batteries. Do not dispose of
batteries in a fire as they may
explode.
AAA
AAA
AAA
AAA
1) Remove the cover on the back of the remote control.
2) Insert the batteries with the (+) and (-) ends pointing in the
correct direction.
3) Install the cover on the remote.
NOTE: The exhaust hose must
be used in cooling mode in order
to cool a room.
NOTE: Fan Only mode does not
require that the exhaust hose be
attached.