Filter
Top Products
Cleaning Floors
Refilling the water tank
• Switch the machine off using the on/off
button.
• Disconnect the power cable from the
electrical outlet. Wait 5 minutes before
squeezing the safety trigger to make sure the
machine is no longer under pressure before
unscrewing the safety cap. DO NOT unscrew
the safety cap until the steam has stopped.
• Fill the water tank as necessary using the
funnel provided. DO NOT exceed 1200ml of
water before replacing the safety cap by
turning clockwise. Fasten cap tightly.
• You are now ready to switch the machine on
and resume steam cleaning.
RED
LIGHT
ON/OFF
SWITCH
ORANGE
LIGHT
3
2
MAX 1200ml
1
6
4
101112
13
8
a
5
9
8
3
7
2
Instructions for Use
• Make sure the machine is unplugged from
the electrical outlet.
• Unscrew the safety cap (6) by turning
anti-clockwise.
Please note the cap cannot be unscrewed
when the unit is pressurized.
• Using the measuring jug (2) and funnel (3) fill
the machine up to 1200ml of water. This
should be sufficient to steam clean for
approximately 30 minutes.
• Once full, replace the safety cap by turning
clockwise and fasten tightly.
• Attach the accessory or floor cleaning tool
you require to the machine. (See page 5)
• Now plug the machine into the electrical
outlet and switch on. Two lights should
illuminate. The red light is a power indicator.
The orange light indicates that the machine is
building steam pressure.
When the machine is first turned on this light
will illuminate. The machine takes up to 7-8
minutes to reach the correct pressure level
depending on the amount of water in the
tank.
• Once the orange light has gone out the
machine is ready to use. The orange light
may come back on when the machine is in
use. If this happens, release the safety trigger
and allow the steam pressure to build up
once again. This should take no longer than
40 seconds. If the safety trigger is pressed
when the orange light is on, hot water may
come out of the machine.
6