Filter
Top Products
a. Boiler F78
b Floor Cleaning Tool AC254
cTowel for Floor Cleaning Tool AC275
d Upholstery Cleaning Tool AC250
eTowel for Upholstery Cleaning Tool AC276
fWindow/Tile Cleaner AC258
g Jet Nozzle AC262
h Scraper AC21
i Brush AC25
j Long Handle (3 tubes) AC01
k Universal Handle AC302
l 3.65 metre Steam Hose ST94
m Castors (not shown) F17
n3 Metre Cord Set (not shown) B17
COMPONENT LIST
a
b
c
d
e
f
g
h
i
j
k
l
ASSEMBLING THE ACCESSORIES
The Universal Handle is used in conjunction with the Floor Cleaner, Upholstery Cleaner, Window / Tile
Cleaner and Jet Nozzle. Align the outline triangle on the handle with the triangle on the accessory.
Push the handle into the accessory and twist so that the solid triangles on the handle and accessory
are aligned (Fig.1).
Over time, you may find that your steam cleaning accessories become awkward to assemble to the
universal handle. This is due to the steam reducing the lubrication properties of the ‘O’ ring seals. In
this event, simply lubricate the ‘O’ ring seals as illustrated (Fig.2) using washing-up liquid or furniture
polish.
The Long Handle Attachment is designed to be used when cleaning floors or hard to reach areas. To
assemble, pass hose through each of the long handle sections, in at the small end out at the large end.
Screw the hose nut onto the universal handle and push the
long handle tube sections together and onto the taper on the
universal handle (Fig.3). You can use
one, two or three sections of the long
handle. Disconnect in reverse order.
If you have any difficulty in
disconnecting twist the handles
apart.
Fig.1
Assembling
Universal
Handle
Fig.2 Seal Lubrication
CASTORS
The castors are packed separately. Turn the boiler upside down and insert the 3 castors. These should
be pushed in hard until they stop. Once installed these remain in place permanently.