Filter
Top Products
.
(iii) Take extra care when vacuuming on stairs; do not work with the vacuum cleaner above you
on the stairs. Do not put the vacuum cleaner on chairs, tables etc.
(iv) Ensure machine is in upright position before using tools.
To release the wand, open the wand cap, press button and lift up. Rotate the wand and clip
handle into hose. Tools can be attached to either the hose or wand.
The brushbar will not rotate when the machine is in an upright position.
Emptying the Clear bin
TM
Caution:
(i) Switch ‘OFF’ and unplug machine before emptying the bin.
Empty as soon as the dirt reaches the level of the MAX mark – do not overll. To remove the
clear bin
TM
from the machine press the button at rear of carrying handle. To release the dirt, press
the button again to open the bin.
Please note:
(i) Do not use the machine without the clear bin
TM
in place.
Cleaning the Clear bin
TM
Caution:
(i) Do not immerse the whole cyclone in water or pour water into the cyclones.
(ii) Ensure bin is completely dry before replacing.
Please note:
(i) Do not use detergents, polishes or air fresheners to clean the bin.
(ii) Do not put bin in a dishwasher.
Washing your lters
Caution:
(i) Switch ‘OFF’ and unplug machine before removing the lters.
(ii) Ensure lters are completely dry before retting to machine.
This machine has two lters, located as shown. It is important to check your lters regularly and
wash at least every month according to instructions, to maintain performance. The lter in the
ball should be rinsed and tapped out until the water runs clean, then tapped out again to ensure
all excess water is removed. This will normally require up to 10 rinse cycles. Please leave to dry
completely for 24 hours.
Please note:
(i) It is normal for this lter in the ball to turn grey in color. The lters may require more
frequent washing if vacuuming ne dust.
(ii) Do not use detergents to clean the lters.
(iii) Do not put the lters in the dishwasher, washing machine, tumble dryer, oven, microwave
or near an open ame.
Looking for blockages
Caution:
(i) Switch ‘OFF’ and unplug machine before checking for blockages. Failure to do so could
result in personal injury.
(ii) Please ensure machine is upright and switched off before removing hose or airway
inspection parts.
(iii) Beware of sharp objects when clearing blockages.
(iv) Ret all parts of the machine securely before using.
Please note:
(i) Clearing blockages is not covered by your machine’s limited warranty. This machine is tted
with a thermal cut-out. If any part of your machine becomes blocked, it may overheat and then
automatically shut off. Switch ‘OFF’ and unplug machine and leave to cool down for at least
60 minutes before attempting to check lters or for blockages. Clear blockage before restarting.
SAVE THESE INSTRUCTIONS
THIS APPLIANCE IS INTENDED FOR HOUSEHOLD USE ONLY
17806_DC24_US_ALL_FLOORS_OPS_MA_ WARNING_UPISSUE.indd 11 5/12/07 13:45:08