Filter
Top Products
1. Remove soleplate
Undo three cross-head screws.
Remove soleplate by lifting from the back, and then
remove brush bar.
If cradle becomes detached from soleplate, align
circular ends of cradle with corresponding holes of
soleplate and slot into place, ensuring that ‘front’
edge of cradle faces the right direction.
3. Centralise belt
2. Line up brush bar
Thread removal
After unplugging the cleaner, carefully remove any
entwined cotton, wool or fluff with scissors.
NOTE: Failure to remove these may result in loss of
performance and possible damage to the machine.
3.Changing the belt
Replacement belts are available direct from
Dyson Customer Care
(
Tel: 1
800 239 766)
Fit belt over motor
shaft and domed
section of brush bar.
Pull belt taut and
locate brush bar
in slot.
1
2
1
2
DYSON CUSTOMER CARE
PO BOX 2175
TAREN POINT
NSW 2229
AUSTRALIA
1
1
1
2
2
With raised section
on end of brush bar
orientated as
shown, locate brush
bar in slot and
rotate end cap
towards back of
machine until it
comes to a stop.
End cap of brush bar
Raised section
3
Cradle
Soleplate
IMPORTANT
Use only genuine Dyson belts.
Helpline 1800 239 766
Facsimile (02) 9526 7122
Contact for all service assistance
3
1
2
Rotate brush bar by
hand to centralise
belt before re-fitting
soleplate to machine.
VERY IMPORTANT
WARNING! For your own safety please
remember to unplug the machine when not
in use and before carrying out maintenance.