Filter
Top Products
• Select a firm, level, flat
location — at least six
inches (15 cm) from any
wall for proper air flow
and convenient to an elec-
trical outlet.
• Place the humidifier on
a water-resistant surface,
as water can damage fur-
niture and some flooring.
Duracraft
®
will not accept
responsibility for property
damage caused by water
spillage.
We recommend that the
humidifier be disinfected
prior to first use. Please
see CLEANING instruc-
tions.
• Remove the Water Tank
by grasping handle and
pulling straight up. Set
aside (Fig. 1).
• Remove the Upper Motor
Housing from the Reservoir
Base, being careful not to
let the power cord drop
into the base (Fig. 2).
• Remove the Natural
Cool Moisture
™
filter from
its frame in the Reservoir
Base (Fig. 3). Run it under
cold water; this will help
reduce residue build-up.
Turn the filter upside down
before repositioning it in
its frame. Replace in the
humidifier. To help extend
the life of your filter,
repeat this step every time
you fill your humidifier.
• Turn the Water Tank
upside-down so that
the fill cap is facing up;
unscrew the fill cap by
turning it counter-clock-
wise.
• Fill the tank with
COOL tap water (Fig. 4).
Distilled water is not nec-
essary as the water is fil-
tered by the Natural Cool
Moisture
™
filter. DO NOT
USE HOT WATER.
• Replace the fill
cap by turning it
clockwise. DO NOT
OVER TIGHTEN.
NOTE: WHEN CARRYING
THE FILLED WATER TANK,
PLEASE USE THE HANDLE
AND PLACE YOUR OTHER
HAND UNDER THE
TANK FOR ADDITIONAL
SUPPORT.
SET UP
HIGH
NORMAL
OFF
POWER
HIGH
DESIRED
HUMIDITY
LOW
HUMIDITY
LEVEL
MOISTURE
OUTPUT
●
●
●
●
●
●
●
●
●
●
➡
➡
FIG. 2
FIG. 3
➡
FIG. 1
FILLING
FIG. 4