Duracraft DH-722 Humidifier User Manual


 
SET UP
NOTE: We recommend that the humidifier be disinfected prior to first use.
Please see CLEANING instructions.
Select a firm, level, flat location at least six inches (15 cm) from any wall
for proper air flow and convenient to an electrical outlet (Fig. 1).
Place vaporizer where it is out of the reach of children. Make sure cord is
not in an area where it can be tripped over or pulled on. Be sure that the
steam outlet is pointed away from any person.
Place the vaporizer on a water-resistant surface, as water can damage
furniture and some flooring. Duracraft
®
will not accept responsibility for
property damage caused by water spillage.
Fig. 2
1. To remove the Steam Assembly, hold the Base and turn the Steam Assembly
counter-clockwise then pull up.
2. Fill the Base with COOL tap water to the indent marked Full Level located on
the back of the unit (Fig. 2).
DO NOT USE HOT WATER. Doing so may
damage the vaporizer.
3. Replace the Steam Assembly back onto the Base. Turn it clockwise
to lock in place. Once the Steam Assembly has been positioned, do not
attempt to move vaporizer. If it has to be moved, unplug it and empty the
Base first.
CAUTION: DO NOT PLUG IN THE HUMIDIFIER WITH WET HANDS AS AN
ELECTRIC SHOCK COULD OCCUR.
4. Plug the filled vaporizer into a polarized 120V outlet. DO NOT FORCE THE
POLARIZED PLUG INTO THE OUTLET; it will only fit one way.
FILLING
Fig. 1
Full Level
Indent
WALL
6" minimum