Filter
Top Products
commode assembly
instructions and precautions
assembling commode
seat and lid:
1. Before assembling, allow toilet seat and lid to
reach room temperature if exposed to cold.
This will help prevent the seat and lid clamps
from cracking while being assembled onto
commode back frame rail.
2. Align the toilet seat clamps onto the back
frame rail. (Both clamps should sit outside
the pail brackets.) Push down on seat until
clamps snap firmly into place.
3. Slide pail in from front of commode.
1. Toilet seat must be in down position before
use. Failure to do so may result in breakage
of commode and possible injury.
2. Do NOT install commode without first
reading and understanding this assembly
and instruction sheet. If you can not
understand these instructions, contact a
healthcare, dealer or technical professional
before attempting to install. Otherwise,
injury or damage may occur.
3. Inspect all parts for shipping damage
before assembly. If there is shipping damage
- DO NOT USE. Contact dealer/carrier for
further instructions.
4. Ensure ALL screws, nuts and/or bolts are
tightened.
5. Check the rubber tips on the leg extensions
for rips, wear or if they are are missing.
Immediately replace any or all if any of these
imperfections exist.
6. All four leg extensions with rubber tips MUST
touch the floor simultaneously at all times.
7. Users with limited physical strength should be
supervised or assisted while using commode.
8. Use the arm supports only for assistance.
DO NOT attempt to use the arms to support
full body weight.
9. Arms should be unlatched and dropped to
assist in transfer onto/off the device.
additional precautions:
FIGURE 1
Seat Clamps
MAX WEIGHT: 850 LBS