Filter
Top Products
ENGLISH
Volvo L-5 A/C - Air Distribution System
4
The instructions that follow represent years of development of parts and procedures
that make the system perform well and appear “factory-installed.”
INTRODUCTION
INSTALLING THE CONTROL
Mount the control in a place that provides the driver
convenient access. An ideal location would be near
the current HVAC controls.
Required Tools
• Drill motor
• Hole saws: 1-5/8", 1-7/8", 2-1/2", 3.5" (for 10K unit)
and 4"
• Drill bits: 1/8", 5/32", 9/32"
• Nut drivers: 1/4", 3/8", 15/16"
• Phillips head screwdriver
• Open-end wrenches: (2) 7/16", (1 each) 5/16", 13/16"
& 3/4"
• Torque wrench may be also be required
Figure 1. Typical Control Installation
Installing the Qt Digital Display
Refer to the mounting instructions and template
provided with your kit.
• Route the CXP cable through the wall and into the
luggage compartment. Remove the factory HVAC
control panel to do this.
• Route the CXP cable to the rear of the bunk for later
connection.