Filter
Top Products
ENGLISH
5
Volvo L-5 A/C - Air Distribution System
Mounting the Power Logic Box
The Power Logic Box (PLB) will be mounted under
the rear, center portion of the bunk (see Figure 2). To
accomplish this, rst remove the carpeted panel at
the rear of the bunk. It is held in place by “Christmas
trees” at each corner.
Remove the backing plate from the PLB, by removing
the four machine screws at the bottom (see Figure 3).
Place the backing plate on the front of the bunk
center area, off center toward the passenger side.
Locate the two weldnuts, and place the backing plate
between them. Mark the four mounting holes, and
remove the plate.
Drill four diameter 7/32" holes. Use four #10 machine
screws to mount the box. The easiest way to do this
is to put the machine screws through the holes, and
secure with a nut. Replace the mounting plate onto
the PLB. Slide the PLB behind the bunk, and push
Figure 2. Mounting location for Power Logic Box