Filter
Top Products
4
CENTRAL RV VACUUM
FIG. 3
FIG. 2
CUT OUT
OPENING
7-3/4” x 15-7/8”
6” MIN
CLEARANCE
WALL
TAPE TEMPLATE
TO WALL
FLOOR
2. Flush Mount installation
a. To reach with vacuum hose as far as possible,
choose a wall or surface that is centrally located
and has a nearby 110 Volt AC power connection.
The vacuum cleaner requires 3-7/8” wall depth
(measured from the front of the wall).
b. Attach paper template with tape to wall or sur-
face a minimum of 6“ above the floor, if mounted
in a vertical position. This will allow sufficient clear-
ance for exhaust air. See FIG. 2.
g. Test unit for operation before installing. Check to
be sure vacuum cleaner bag, motor filter, exhaust
filter and gate are in place. See Operating Instruc-
tions, Steps D, E, and F. Slide the unit , bottom
first into the opening and secure to wall with the 4
wood screws.
Note: Never use vacuum cleaner without dust bag
or motor filter in place.
Note: Optimal installation uses 6 wood screws
instead of 4 to reduce risk of loosening due to
road vibration.
C. GROUNDING INSTRUCTIONS - EXTERNAL MOUNT
1. This appliance must be grounded. If it should mal-
function or breakdown, grounding provides a path of
least resistance for electric current to reduce the
risk of electric shock. See FIG. 3.
D. GROUNDING INSTRUCTIONS - FLUSH MOUNT
2. For permanently connected appliances, (in-wall in-
stallation) this appliance must be connected to a
grounded metal permanent wiring system; or an
equipment-grounded conductor must be run with
the circuit conductors and connected to the equip-
ment grounding terminal or lead on the appliance.
Note: All wiring must comply with the National Elec-
trical Code ANSI/NFPA 70-(latest edition); or CSA
Standard C22.1, Canadian Electric Code, Parts 1
and 2; and any applicable local codes.
c. Tape the template to the mounting surface of the
desired location. The bottom of the cut out must
be the minimum of 6” above the floor.
d. Center punch all of the circles with an awl or nail.
Remove the template. Draw a line connecting the
circles using a pencil and straight edge. This will
outline an area 7-3/4” x 15-7/8” that is to be cut
out.
e. Drill the 4 corner marks with a 1/16” drill bit, then
saw out the opening. Be sure to follow the line as
the mounting holes are close to the edge of the
cut out.
Note: Instructions also printed on paper template.
f. Place the vacuum cleaner upside down with its’
back towards you. Remove the 2-3/4 ”x 1-3/8”
cover plate on the vacuum cleaner. Install 16 AWG
cable (rated at 90
0
C) to the unit.
Use nonmetallic
sheathed cable with ground (Romex) or flexible
metal conduit with ground, to electrical outlet.
(Check your local electrical code.) Make the
connection through the Romex clamp (do not
pinch wiring). Replace cover plate.
There may be electrical wiring in the wall.
Disconnect AC power cord and the positive
(+) 12 volt DC terminal at the supply bat-
tery. Failure to follow this instruction may
create a shock hazard causing death or se-
vere personal injury.
WARNING
!
To avoid possible electrical shock, be sure
that electricity is turned off at the main switch
or circuit breaker.
CAUTION
!