Filter
Top Products
8
IMPORTANT INFORMATION BEFORE OPERATION
1. Fill freshwater tank and add deodorant to holding tank through toilet bowl.
2. Make sure all guests understand the operation of the toilet system. 3300 models:
This flushing instruction label is located under the seat, and is easily read when the
seat is raised. 3400 models: "Add Water" and "Flush" are clearly marked on the
remote switch.
3. Shut off the toilet system before servicing and do not leave the vehicle with toilet system circuit breaker on.
4. Never use drain openers, alcohol, solvents, etc. in the toilet.
5. If the toilet does not function properly, refer to the Troubleshooting section of this manual and repair as neces-
sary. If problem persists, contact your local SeaLand product dealer or see the Customer Service section of
this manual.
1. To add water to the toilet
before using (if neces-
sary), raise flush handle
until desired water level
is reached. (Water flow
will stop automatically
after a pre-programmed
period of time).
2. To flush toilet, press flush
handle down. Water will
flow into bowl for two sec-
onds, then flush ball will
open. Toilet will not flush
again until water refill cycle
is complete.
FLUSH HANDLE TOILET
TOILET CONTROLS
ACCESS COVER
OFF
FLUSH
ADD WATER
TO BOWL
OFF
FLUSH HANDLE
(3300 models)
CONTROL
SWITCH
Figure 1
ELECTRONIC FLUSH AND FORGET
®
OPERATION
REMOTE FLUSH
SWITCH TOILET
1. To add water to
bowl, press top
part of switch.
2. To flush, press
bottom part of
switch.
Do not dispose of san-
itary napkins or other
non-dissolving items in
toilet, such as facial tissue
or paper towels. These
items can cause plugging
of the system.
DO NOT FLUSH
FOREIGN OBJECTS
THROUGH TOILET
REMOTE FLUSH SWITCH
(3400 models)