Filter
Top Products
ENTREPOSAGE L’ÉTÉ
1) Nettoyez l’appareil tel qu’indiqué dans le chapitre portant sur les
« Soins et l’entretien ».
2) Jetez les filtres à mèche usés et toute eau dans le récipient. Laissez
le boîtier sécher complètement avant de le ranger. N’entreposez
pas l’appareil avec de l’eau dans le récipient.
3) N’entreposez pas l’appareil dans un grenier ou dans un endroit où la
température est élevée.
4) Installez un nouveau filtre à mèche avant le début de la saison.
18
ASSEMBLY, CONTROLS & OPERATION
ASSEMBLY
1) Unpack humidifier from carton and remove all packaging material, wicks,
etc. from box. Remove foam from bottle.
2) Place the humidifier “cabinet” with evaporative wick at the location where
the product will be operated at least 4 inches from the wall. Fill bottle.
Replace cap and tighten securely. Using both hands to carry the bottle to
the base. NOTE: If only softened water is available, it can be used;
however you will notice a build up of minerals on the evaporative wick
much sooner. Do not spill water on fan motor. Electrical
components must be kept dry.
3) Make sure wick is resting all the way into the water
channel as indicated by the illustrations, making sure
the wick is resting all the way into the water channel.
4) Return bottle to its upright position using the handle
on the top of the bottle. Set the bottle in the recessed
area, the top of the bottle flush with the top of the
humidifier. See illustration. When positioned properly,
the valve will open and water will flow into the water
channel.
5) We recommend using Essick Air Bacteriostat
Treatment whenever you refill the humidifier reservoir
to eliminate bacterial growth. Add bacteriostat according to the
instructions on the bottle.
6) Plug cord into wall receptacle and turn humidifier on.
**When excessive condensation exists, a lower speed setting is
recommended.
CAUTION: Disconnect power before filling, cleaning or servicing unit.
Keep grille dry at all times.
OPERATION & CONTROLS –
1) The humidifier should be placed at least FOUR inches away from any
walls and away from heat registers. Do not place on soft carpet.
Unrestricted airflow into the unit will result in the best efficiency and
performance. Set desired levels and speed.
2) The digital control allows you to use the low setting for the quietest
operation or a high setting for maximum output.
3) For initial operation, push the speed button once for the sleep setting
and continuously press the button to increase desired speed. TO STOP
the unit, press the speed button for two seconds, or keep pressing
button until display reads OFF.
4) To take advantage of the digital humidistat, press the speed button to
any setting other than OFF
. Then adjust the set humidity by using the up
and down buttons. Humidity will increase in increments of 10%. When
the room humidity level rises above the set humidity, the humidifier will
stop. When the humidity level drops below the set humidity, the
humidifier will turn on automatically.
3
Wick
Placement