Filter
Top Products
-
. .
.
.
- -
. .
-
-
-
-
:HANGING BELT OR BRUSHROLL.
0
REMOVE BELT
ay cleaner flat and flip
leaner to expose nozzle
ase. Base should lay flat
id face up. To remove noz-
e guard, use Phillips or Flat
ead screwdriver to remove
le five (5) screws. Arrows
low location of screws.
Vith new belt in place, pull
nd slide brushroll into
nozzle
iaking sure that the brushroll
nd caps are in the correct
rientation (6a inset). Rotate
,mshroll manually to make
ure belt is properly aligned.
I
I
Lift nozzle guard off.
Be sure belt is off motor
shaft. Lift and remove
brushroll. Dispose of old belt.
TO REPLACE BELT OR BRUSHROLL
Slide belt onto motorshaft.
Place new belt in area of
brushroil without bristles.
I
Reattach nozzle guard.
I
TAB
TAB
TAB
1
Secure by aligning the three
(3)
tabs in the base slots.
Replace all five (5) screws
to secure nozzle guard.