Filter
Top Products
UPPER LIGHT BULB REQUIREMENTS
Quantity of 1 clear chandelier or candelabra bulbs with an E-12 (small) socket base, 7 watt
rating.
GLASS CLEANING
The glass is cleaned in the factory during the assembly operation. During shipment,
installation, handling, etc., the glass surface may collect dust particles, these can be removed
by buffing lightly with a clean dry cloth.
To remove fingerprints or other marks, the glass can be cleaned with a damp cloth using a
good quality household glass cleaner. The glass should be completely dried with a lint free
cloth or paper towel. Do not use abrasive cleaners on glass surface or spray liquids directly
onto any surface.
milano
ef
SURFACE CLEANING
Use warm water only to clean painted surfaces of the milano
ef
. Do not use abrasive cleaners
on glass surface or spray liquids directly onto any surface.
TO REPLACE THE LOWER LIGHT BULBS
1. Unscrew the two black knobs on the front of the unit by turning counterclockwise.
2. Grasp onto the front door, gently lift up and pull the door off of the unit.
3. Remove the screw from the logset located in the center of the emberbed and remove the
logset from the unit.
4. Locate and examine the bulbs to determine which bulb(s) required replacement.
5. Unscrew the bulb(s) counter clockwise.
6. Insert new bulb(s).
7. Install the logset into the unit, pushing firmly against the glass. Replace the logset retaining
screw into the ember bed.
8. Install the front door over the threaded rods, gently lifting up to engage the door into the slot
in the roof.
9. Screw the two black knobs clockwise until tightened.
TO REPLACE THE UPPER LIGHT BULB
1. Unscrew the two black knobs on the front of the unit by turning counterclockwise.
2. Grasp onto the front door, gently lift up and pull the door off of the unit.
3. Unscrew the bulb counter clockwise.
4. Insert new bulb.
5. Install the front door onto over the rods, gently lifting up to engage the door into the slot in
the roof.
6. Screw the two black knobs clockwise until tightened.
HELPFUL HINTS
It is a good idea to replace all light bulbs at one time if they are close to the end of their rated
life. Group replacement will reduce the number of times you need to open the unit to replace
light bulbs.
4