NOTE 1
A 15amp, 120 volt outdoor GFI is required. Additional appliances on the same circuit may
exceed the current rating of the circuit breaker.
WARNING
Ensure the power cord is not installed so that it is pinched or against a sharp edge and ensure
that the power cord is stored or secured to avoid tripping or snagging to reduce the risk of fire,
electric shock or injury to persons.
Construction and electrical outlet wiring must comply with local/national building codes and
other applicable regulations to reduce the risk of fire, electric shock and injury to persons.
Do not attempt to wire your own new outlets or circuits. To reduce the risk of fire, electric
shock or injury to persons, always use a licensed electrician.
SITE SELECTION AND PREPARATION
This section provides instructions for selecting a location and preparing the site to install the
fireplace into your Dimplex mantel surround.
1. Select a suitable location.
2. For ease of electrical hook up you may wish to locate the fireplace near an existing
outlet. (Refer to NOTE 1).
NOTE
The dimensions of the fireplace are 27.60”wide X 20.10” high X 9” deep. The viewing area is
26” wide and 13” high.
3
20 Feet
Figure 2