Filter
Top Products
NOTE
A 15amp, 120 volt alternating current (VAC) circuit is required. A dedicated circuit is preferred
but not essential in all cases. A dedicated circuit will be required if, after installation, the circuit
breaker trips or fuse blows on a regular basis when the heater is operating. Additional
appliances on the same circuit may exceed the current rating of the circuit breaker.
WARNING
Ensure the power cord is not installed so that it is pinched or against a sharp edge and ensure
that the power cord is stored or secured to avoid tripping or snagging to reduce the risk of fire,
electric shock or injury to persons.
Construction and electrical outlet wiring must comply with local building codes and other
applicable regulations to reduce the risk of fire, electric shock and injury to persons.
Do not attempt to wire your own new outlets or circuits. To reduce the risk of fire, electric
shock or injury to persons, always use a licensed electrician.
(NO ASSEMBLY REQUIRED FOR THE FLAT WALL MANTEL)
CORNER MANTEL ASSEMBLY
1. Assemble the top of the mantel to the rear support using the supplied hardware.
2. Using the supplied hardware assemble the top and rear support assembly to the main
fireplace body.
FIREPLACE INSTALLATION
1. Make sure the units MAIN ON/OFF switch is switched OFF (refer to operating
instruction section).
2. Plug the unit into a 15Amp/120VAC outlet. If the cord does not reach, you may use a
No. 16 AWG minimum size extension cord rated for a minimum of 1875 watts.
3
REAR
SUPPORT
MAIN BODY
MANTEL
TOP
HARDWARE
OR