Filter
Top Products
RESETTING THE TEMPERATURE CUTOFF
SWITCH
Should the heater overheat, an automatic cut out will
turn the heater off and it will not come back on
without being reset. It can be reset by switching the
MAIN ON/OFF SWITCH to OFF and waiting 5
minutes before switching the unit back on.
CAUTION
If you need to continuously reset the heater, unplug
the unit and call customer service at
1-800-668-6663.
MAINTENANCE
WARNING: Always disconnect from the power
supply before attempting any maintenance.
Bulb Replacement - see Fig.’s 3, 4 & 5
There are two bulbs located under the ember bed.
To gain access to the bulbs, remove the coal/
pebbles and place in a container. Remove the front
panel from the fireplace by lifting it up and out from
the slots on the fireplace - see Fig.3.
Remove the rotisserie by carefully sliding the rubber
connecter off the motor shaft - see Fig. 4.
Remove the defective bulb by unscrewing it as
shown in Fig.5.
Replace with a 60W E12 clear chandelier or
candelabra bulb. Take care not to over-tighten the
bulb.Refit the front panel and replace the coal/
pebbles.
7