Filter
Top Products
battery terminals are protected and well insulated from materials
that could contact them and cause a short circuit.
Char
ging Procedure
DW9104, DW9106, DW9107, DW9108, DW9109
(1 HOUR CHARGERS) ONL
Y
1. Plug the charger into an appropriate AC power outlet.
2. Insert the battery pack into the charger, making sure the pack is
fully seated in the charger. The red (charging) light will blink
continuously indicating that the charging process has started.
3. The battery pack will be fully charged in about 1 hour under
most conditions. The completion of charge will be indicated by
the red light remaining ON continuously. The pack is fully
charged and may be used at this time or left in the charger.
DW9115 (15 MINUTE CHARGER) ONLY
1. Plug the charger into an appropriate AC power outlet. The
charger will beep twice and the red light will blink and then go
off.
2. Insert the battery pack into the charger, as shown in Figure 1,
making sure the pack is fully seated in the charger. The red light
will blink and the charger will beep once indicating the charging
process has started.
3. The battery pack will be fully charged in less than 15 minutes
under most conditions. This will be indicated by the red light
remaining ON and 3 audible beeps. The pack is fully charged
and may be used at this time or left in the charger.
Power Pack Inser
tion and Removal
T
o insert the power pack into your flexible floodlight, slide it into the
end of the light until it snaps into place. To remove the power pack,
depress the release buttons shown and withdraw the power pack.
Switch
T
o turn the light on, slide the switch forward. To turn it off, slide the
switch back.
Replacing the Light Bulb
Floodlight Cat. No
Replacement Bulb Cat. No.
DW913 DW9023
DW917 DW9043
DW918 DW9063
DW919 DW9083
To replace the light bulb, first unscrew the lens holder. Pull the bulb
out of the spring, and insert a new bulb. Reinstall lens holder.
NOTE: Do not look directly into the flexible floodlight beam.
Spar
e Bulb Storage (Fig. 2)
T
o store a bulb, unscrew the lens holder and remove it. Inside the
body of the flexible floodlight is the storage socket. To remove the
bulb, pull it up and out of the storage area.
NOTE: Removing a pack from the charger and immediately
inserting it into the flexible floodlight may weaken bulb life.
The RBRC™ Seal
The RBRC™
(Rechargeable Battery Recycling
Corporation) Seal on the nickel-cadmium battery
indicates that the costs to recycle the battery at the
end of its useful life have already been paid by
D
E
W
ALT. In some areas, it is illegal to place spent
nickel-cadmium batteries in the trash or municipal solid waste
stream and the RBRC program provides an environmentally
conscious alternative.
RBRC in cooperation with D
E
WAL
T and other battery users, has
established programs in the United States to facilitate the collection
of spent nickel-cadmium batteries. Help protect our environment
and conserve natural resources by returning the spent nickel-
cadmium battery to an authorized service center or to your local
retailer for recycling. You may also contact your local recycling
center for information on where to drop off the spent battery.
FIG. 1 FIG. 2
LENS HOLDER
POR
TE-LENTILLE
SUJETADOR DE LA LENTE
BULB
AMPOULE
BOMBILLA
BA
TTERY RELEASE BUTTON
BOUTON DE DÉGAGEMENT
DE LA PILE
BOTON DE LIBERACION DE
LA BATERIA
SPARE BULB STORAGE
RANGEMENT DE L’AMPOULE
DE RECHANGE
COMPARTIMIENTO PARA
BOMBILLA DE REPUESTO
POWER P
ACK (NOT INCLUDED)
ENSEMBLE DE PILES
(NON COMPRIS)
BATERIA (NO INCLUIDA)
SWITCH
INTERRUPTEUR
INTERRUPT
OR
DeW
alt electric
Power tools