Filter
Top Products
www.desatech.com
122025-01A
3
Figure 4 - Attaching Mantel Top
1
1
/
4
" Screw
Washer
Mantel Top (#7)
Mantel Side
Assembly
FINISHING MANTEL
Starting with left side leg assembly, tighten screws using
Allen wrench provided. Tighten screws on the right side leg
assembly, header, top assembly and base.
MANTEL TOP ASSEMBLY
1. Start two 1
1
/
4
" screws with washers through each of the
three header assembly blocks (#8) and into threaded
inserts on mantel as shown in Figure 4.
2. Place mantel top (#7) on mantel assembly. Align back of
top with back of sides. Using six 1
1
/
4
" screws with wash-
ers, install two in each header assembly block (#8) (see
Figure 4). Make sure all pieces are aligned properly and
tighten all screws.
Top
Assembly
Blocks (#8)
Figure 5 - Installing Reed Panels
ELECTRIC FIREPLACE INSTALLATION
This mantel can be used with any DESA Heating Products
26" electric replace. Electric replaces install from the front
of mantel. To install electric replace see replace instruction
manual. Use caution when positioning replace on base. Base
may scratch easily.
REED INSTALLATION
1. Mantel kit contains two sets of reed panels. A dark set
(Espresso) and a light set (Fruitwood). Determine which
set you prefer. Store second set in safe, dry location on a
at surface to interchange in the future if you so desire.
2. Slide front reed panel (#11 or #13) into track on front of
mantel top (see Figure 5).
3. Slide left and right reed panels (#10 or #12) into tracks
on sides of mantel top. Be sure panel colors match.
4. Install 4 corner trim pieces (#14) by sliding onto dovetail
guide on mantel top (see Figure 5). Corner pieces should
slide on easily. Do not apply excessive force to prevent
breakage.
Note: Reed panels can be changed after installation.