Filter
Top Products
www.desatech.com
119492-01B
2
2. Assemble left side (#4) and left leg (#5) as described in step 1.
3. Attach 6 brackets to base (#1) at threaded hole locations us-
ing 1/2" screws leaving screws loose. Face brackets toward
outside.
4. Place right side/leg assembly on base and align threaded holes
with brackets. Start 1/2" screws through brackets into threaded
holes in side/leg assembly. Back of side/leg assembly should
be ush with back of base. Assure alignment is correct and
spaces are at a minimum. Leave screws slightly loose.
5. Assemble left side/leg assembly to base following step #4.
Figure 1 - Right and Left Leg Assemblies
Figure 2 - Leg Assembly to Base
Figure 3 - Attaching Header
Mantel Top Assembly
Place mantel top (#7) on mantel assembly. Align back of top with
back of sides. Using seven 1
1
/
4
" screws with washers, place two
in each mantel side assembly and three in the header (see Figure
4, page 3). Make sure all pieces are aligned properly and tighten
all seven screws.
Header Assembly
1. Using 1/2" screws, secure brackets to two threaded holes at
both ends of header (#6). Turn brackets to the outside.
2. Place header (#6) into position on top of leg assemblies with
arrow pointing up. Bottom of header will slide in behind upper
portion of leg front panels and rest on shoulders (see Figure
3). Align bracket holes with threaded inserts in leg assemblies.
Using four 1/2" screws through brackets, attach header to leg
assemblies. Leave screws loose.
3. Be sure alignment is correct and spaces are at a minimum
having at least one person holding panels securely. Tighten all
screws with Allen wrench provided.
Leg Side (#4)
Leg Front (#5)
Tongue on
Leg Side
Groove in
Leg Front
Tongue on
Leg Side
Groove in
Leg Front
1/2" Screw
Bracket
1/2" Screw
Bracket
Right
Side/Leg
Assembly
1/2" Screw
Bracket
Threaded
Insert
Shoulder of
Leg Front
Panel
Header
(#6)
Base (#1)
Leg Side (#2)
Leg Front (#3)