Filter
Top Products
www.desatech.com
113093-01H22
OPERATION Continued
REMOTE READY MODELS
Figure 26 - Pilot
(Propane/LP)
Ignitor
Electrode
Pilot
Burner
Figure 27 - Pilot
(Natural)
Pilot Burner
The hand-held remote can be operated
using either the manual mode (MANU) or
thermostatic mode (AUTO) (see Figure 30,
page 23). To select Fahrenheit/Centigrade
mode display, carefully press the ˚C/˚F mode
button with the end of a paper clip or similar
blunt object.
Manual Mode
1. Press the POWER and LOCK buttons
together to turn on the hand-held remote
control.
2. Press the MANU button to turn on the
replace.
3. Press the POWER and LOCK buttons
together to turn off the replace.
Figure 28 - Setting the Selector Switch,
Control Knob and Flame Adjustment
Knob for Hand-Held Remote Operation
ON
OFF
REMOTE
O
F
F
P
I
L
O
T
L
O
I
H
O
N
Selector Switch in Remote Position
(Optional Remote Control)
Control Knob
in On Position
Flame Adjustment Knob
Figure 29 - On/Off Hand-Held Remote
Control Unit (HRC100)
Control Button
Turns Burners
On and Off
Note: The burner may light if hand-held re-
mote was on when selector switch was last
turned off. You can now turn the burner on and
off with the hand-held remote control unit.
IMPORTANT: Do not leave the selector switch
in the REMOTE or ON position when the pilot
is not lit. This will drain the battery.
Hold the control button on the hand-held remote
until burner turns on. Hold the control button
again until burner turns off (see Figure 29).
TO LOCK press both buttons on hand-held
remote control until light stops ashing. Hand-
held remote control is now locked. If the re
is on it will be turned off automatically. In the
locked state, the light will not light up when
any button is pressed.
TO UNLOCK press both buttons together
on hand-held remote control until the light
stops ashing. The hand-held remote is now
unlocked.
MANUAL LIGHTING
1. Follow steps 1 through 6 under Lighting
Instructions, pages 20.
2. Depress control knob and light pilot
with match.
3. Keep control knob pressed in for 30 seconds
after lighting pilot. After 30 seconds, release
control knob. Now follow steps 9 through 11
under Lighting Instructions, page 20.
Note: All remote control accessories must
be purchased separately (see Accessories,
pages 31). Follow instructions included with
the remote control.
-
Lighting
Instructions
After lighting, let pilot ame burn for about one
minute. Turn control knob to ON position. Ad-
just ame adjustment knob anywhere between
HI and LO. Slide the selector switch to the
REMOTE position (see Figure 28).