Filter
Top Products
www.desatech.com
111253-01F20
FIREPLACE INSTALLATION
Continued
GLOWING EMBERS
Each log is marked with a number. These numbers will help you
identify the log when installing. It is very important to install these
logs exactly as instructed. Do not modify logs. Only use logs sup-
plied with replace.
Open louvers, remove screen, unlock door latches, and open glass
door. See steps 1 and 2 of Removing/Replacing Glass Door, page 18.
Install logs according to instructions for replace model numbers.
1. Place log #1 (base log) onto pin on left side of burner as shown
in Figure 40.
2. Rest left side of log #2 (front log) onto top of log #1. Place
right side of log onto second pin located on right side of grate
(see Figure 42).
3. Place logs #3 (rear log) onto pin on rear of grate as shown in
Figure 41.
4. Place log #4 (crossover log) onto pins from both logs #2 and
#3 as shown in Figure 43.
5. Place log #5 (top log) onto right pin of front log (#2) and smooth
surface of crossover log (#4) as shown in Figure 44. Make sure
it is seated properly.
6. Place log #6 (left log) onto left pin of front log (#2) and smooth
surface of rear log (#3) as shown in Figure 45. Make sure it is
seated properly.
7. Place log #7 onto right pin of top log (#5) as shown in Figure
45. Make sure it is seated properly.
8. Place lava rock along sides and front of rebox bottom in areas
that are visible only. It is not necessary to use all of the lava
rock provided.
Figure 40 - Installing Log
No. 1
problems.
9. Pull ember material apart into pieces no larger than a dime.
Place these pieces loosely and sparingly directly onto exposed
section of front burner and along space between burner and
grate prongs (see Figure 46). This will create a glowing ember
appearance as the ame touches ember material. Do not block
air slots by using too much ember material in one area. It is not
necessary to use all of the ember material provided.
10. Close glass door, lock door latches, replace screen and close
louvers (see Removing/Replacing Glass Door, steps 5 through
7 on page 19.
WARNING: The glass door must be securely in place
Figure 46 - Placing Ember Material on Burner
The installation of a wall switch allows you to activate the gas
control valve and turn the replace on and off. The wall switch is
to be connected to the incoming 120 volt regular household wiring
that supplies the electricity to the replace. See Wiring Diagram
on page 21.
Note: If using optional wireless hand-held remote control, the wall
switch must be in the ON position to be operational. The remote
control then becomes the switching mechanism for replace op-
eration.
1. Open lower louver panel of rebox.
2. The WRC model receiver does not require a battery. The
receiver can be installed by rst plugging the short extension
cord into the replace receptacle. Then plug the receiver unit
into the extension cord. Finally plug the ignition module plug
into the receiver unit (see Figure 47, page 21).
Ember Material
1
1
2
Figure 41 - Installing Log
No. 2
Figure 42 - Installing Log
No. 3
Figure 43 - Installing Log
No. 4
3
4
Figure 44 - Installing Log
No. 5
Figure 45 - Installing Logs
No. 6 and No. 7
5
6
7